A new line from OIRAN COMBO SERIES has been launched.

Parking, brake, indicator and reverse light are included in all-in-one light. Sequential indicator (light flowing seamlessly) is adopted.

Just replace a Japanese genuine triple tail light.

Just replace a Japanese genuine triple tail light with this full LED tail light.
High luminance 192 LED and 16 LED bar!
Stylish LED bars provide fantastic illumination, so your truck will get attention wherever you go.
This exquisite, extra bright light will give your truck a unique, stylish look like nothing else.
Extremely bright LED is installed in every function; parking, brake, indicator and reverse.
High brightness LED with direct lighting method is installed in the brake light.
Great visibility.
Brightness of the reverse light is 130% of genuine products.
Extra illumination will provide high visibility when you back up the truck.

Red lens/Chromium
Product No: OCSN-RC-M1

You do not have to worry about hyper flash phenomena because a canceller is built in the tail light.

A resistor which is sold separately is necessary for vehicles equipped with a burn-out warning light.

Product# OERO-V2, OIRAN resistor for park and brake, right and left set (sold separately)

illumination images (These images are for right side.

These images have red lens.

Park light illuminated

Indicator illuminated

Brake light illuminated

Reverse light illuminated

Conformed to safety standard

Sequential indicator (light flowing seamlessly) is adopted.

Our sequential indicator has been compliant with Japanese safety standards due to the law amendment.
Your standard indicator can be changed to a sequential indicator by changing the wiring.

Sequential indicator image (the image is for the right)


Width: 499mm Height 200mm Depth 110mm

Conformed to safety standard

ECE standard certified and conformed to safety standard
This product has obtained the E-Mark as the safety standard compliant product.

What is an E-Mark?

An E-Mark is based on EU directive and is a global standard safety certification mark which the European Commission requires. An E-Mark logo is stamped on the products which meet ECE (Economic Commission of Europe) regulation. This is a worldwide quality standard certification.
Normally, Japanese aftermarket parts which are sold worldwide necessarily have this certificate.

Depending on the number of installed products, installation position, and installation method, the vehicle may not pass the inspection, so please check with the store, dealer or installation factory where you purchased the product.


The lens and the body are bonded by Thermo-compression. This method prevents any moisture from seeping into a tail light and improve its durability.


This tail light is covered by one year warranty. It is limited to products with defectives such as lighting defects or water leaking. Please note this warranty is only for use in Japan.